Verifone PIN Pad: Connect to Wifi

With its powerful processing capabilities and advanced security features, your Cardknox device is designed for premium efficiency. Follow the instructions below to connect this WiFi-only terminal to the internet.

This is applicable to the following device(s):

Verifone e285

Verifone e285

Verifone P400

Verifone P400

Verifone P200 Plus

Verifone P200 Plus

Turn On & Connect

  1. To turn on your Cardknox device, press and hold the green button until the Verifone logo appears. (Note: If you release the button before the logo appears, the device will not finish powering on.)
  2. From the Cardknox home screen, press 1, 5, and 9 simultaneously to access the terminal’s main menu.
  3. From the main menu:
    • Select Control Panel.
    • Select Sysmode.
    • Select supervisor.
  4. When prompted, enter the device password: 1668321.
    Press the green button to confirm.
  5. From the Main (Prod) drop-down menu:
    • Select Administration.
    • Select Communications.
    • Select WiFi.
    • Select WiFi Scan.
  6. A pop-up box will appear: “WiFi is off. Do you want to power it on?” Press OK.
  7. Select one of the listed networks.
  8. A pop-up box will appear: “Network Saved.” Press OK.
  9. Press the red button one time to return to the WiFi screen.
  10. From the WiFi screen:
    • Select WiFi Configuration.
    • In the PSK field, enter your WiFi password. (Note: If you enter a character incorrectly, there is no option to backspace. You must clear the field and retype the entire password.)
      • To insert letters and numbers, press the key with the desired character until the appropriate one appears.
      • To switch between alphabets (uppercase, lowercase, and numeric), press the pound (#) key.
      • To insert special characters, choose the lowercase alphabet, and then press 0 until the appropriate symbol appears.
        • Example: To insert the @ symbol, choose the lowercase alphabet, and then press 0 until the @ appears.
  11. After entering your password:
    • Click the green button to confirm.
    • Click the red button to return to the WiFi screen.
  12. From the WiFi screen:
    • Select WiFi Interface IPv4.
    • Change the AutoStart setting from Off to On.
    • Select the Status image to connect. (Note: Before WiFi is connected, the Status image will depict two red plugs, side by side. If you correctly entered the password during Step 10, the two plugs will now connect and turn green. If they do not connect, you will need to press the red button until you are back on the WiFi screen, and then start over from Step 10.)
  13. Once connected, press the red button four times to get back to the Main (Prod) drop-down menu.
  14. From the Main (Prod) drop-down menu:
    Select Run Applications.
  15. Wait for the Cardknox home screen to reappear. The device is now ready for use.